How To Set The Service Menu - Furuno FSS-3BB Installation Manual

3.2

How to Set the Service Menu

3.2.1 How to open the service menu
1. Click the
stantAccess bar
den.
To hide the InstantAccess bar
or right-click with trackball control unit anywhere on the
screen.
2. Click the [Settings] icon (
™
bar , then click the [Advanced Settings] icon (
3. Select [Service] from the menu on the left-hand side of the
window.
The message "Ask your dealer to change service settings." appears.
4. Press and hold the [OK] button for approx. 10 seconds to open the service menu.
IDENTI-FISH
ID1
ID2
Alarm
System
Range
TX/RX
HF
LF
Control Unit
User Interface Settings
Calibration
HF
LF
Stabilization
HF
LF
Mode
Tests
Service
5. Follow the procedures in the remaining sections of this chapter to set up the FSS-
3BB.
To hide the service menu, click the [OK] button again. The message "Ask your dealer
to change service settings." is shown. The service menu is also hidden when the sys-
tem is rebooted.
button at top-left corner to show the In-
™
when the InstantAccess bar
) from the InstantAccess
××.××
Advanced Settings
Service
Ask your dealer to change service settings.
™
is hid-
™
, click the button
).
10 seconds
later
OK
OK
Apply Cancel
Unlocked service menu items.
3. INITIAL SETTINGS
InstantAccess
TM
bar
××.××
HF
LF
Stabilization
HF
LF
Mode
Tests
Service
Shared Settings
*
HF
*
LF
Fish Size *
*
HF
*
LF
*
IDENTI-FISH
*
HF
*
LF
Transducer Setting
HF
LF
*: Not used at installation.
3-5