How to extend the control unit cable
To extend the length of the cable between the trackball control unit and the processor
unit, use the optional cable assembly (6TPSH-XH12X2-LxxSP2, 5/10 m).
1. Unfasten four binding screws (M3×8) from the bottom of the unit, and a pan head
screw (M3×8) and flat washer from the back of the unit to remove the cover.
Note: Remove the cover slowly to prevent damage to the cables connected to the
circuit board in the unit.
Binding screw (M3×8, 4 pcs)
Control unit cover
2. Remove the cable clamp from the trackball control unit, then disconnect the con-
trol unit cable from J1.
Binding screw
Cable clamp
3. Pull out the control unit cable from the cover.
4. Pass the optional cable assembly (6TPSH-XH12X2-LxxSP2) through the cable
hole on the cover.
J1
Disconnect this connector.
Cable assy
(6TPSH-XH12X2-LxxSP2)
Pan head screw (M3×8)
Flat washer
Control unit
cable
2. WIRING
2-11