H3C WA Series Fundamentals Configuration Manual page 121

For more information about AAA and RADIUS, see AAA in the Security Configuration Guide.
Configuration example
1) Network requirements
Assume the AP supports Telnet, and the user level of telnet users is set to the manage level (level 3).
Telnet to the AP, and configure parameters for console login as follows.
Configure the name of the local user as guest.
Configure the local password as 123456 (in plain text).
Set the service type of the local user to Terminal and the command level to 2.
Configure the scheme authentication mode.
Configure the baud rate of the console port as 19200 bps.
Configure the screen to contain up to 30 lines.
Configure the history command buffer to contain up to 20 commands.
Configure the timeout time of the console user interface as 6 minutes.
Figure 14-8 Network diagram for console login configuration (with the authentication mode scheme)
2) Configuration procedure
Configure the AP
# Enter system view.
<Sysname> system-view
# Create a local user named guest and enter local user view.
[Sysname] local-user guest
# Set the authentication password to 123456 (in plain text).
[Sysname-luser-guest] password simple 123456
# Set the service type to terminal.
[Sysname-luser-guest] service-type terminal
# Set the command level to 2.
[Sysname-luser-guest] authorization-attribute level 2
[Sysname-luser-guest] quit
# Enter console user interface view.
[Sysname] user-interface console 0
# Enable scheme authentication for console users.
14-12