H3C WA Series Fundamentals Configuration Manual page 123

Launch a terminal emulation utility (such as HyperTerminal in Windows XP/Windows 2000) and set
Bits per second to 9600, Data bits to 8, Parity to None, Stop bits to 1, and Flow control to None.
Turn on the AP. You are prompted to press Enter if the AP successfully completes the POST. A
prompt appears after you press Enter, as shown in
Figure 14-10 Configuration page
Execute the following commands on the terminal to configure the IP address of VLAN-interface 1
as 202.38.160.92/24.
<Sysname> system-view
[Sysname] interface Vlan-interface 1
[Sysname-Vlan-interface1] ip address 202.38.160.92 255.255.255.0
Step2 Configure an authentication mode for telnet users on the AP. For more information, see
None Authentication for Telnet
Configuring Scheme Authentication for Telnet
Step3 Set up a configuration environment as shown in
VLAN 1 of the AP, and make sure that the PC and VLAN-interface 1 can reach each other.
Login, Configuring Password Authentication for Telnet
Login.
Figure
14-14
Figure 14-10.
14-11. Connect the PC to an Ethernet port in
Configuring
Login, and