Inter-fab X-STREAM SLIDE Assembly/Installation Instructions page 12

I N S T A L L A T I O N M A N U A L
STEP THREE: Attach the Handrails to the Ladder and Entry Section - CONT.
Fig. 7
Fig. 8
Fig. 9
XS-IM Rev. 7/08 (SBK-XS INSTALL)
X - S T R E A M ™ S L I D E
These 3 locations receive a flange nut and a
rubber cap. A flat washer is not needed.
Hand tighten.
Make sure to use the provided lubricant on
the all-threads before attaching the flange
nuts.
These two locations require a flat washer,
flange nut and rubber cap. Hand tighten.
Make sure to use the provided lubricant on
the all-threads before attaching the flange
nuts.
NOTE: 1/8" – 1/4" of the all-threads will
extend through the flange nut.
Now tighten all 6 nuts and repeat for other
handrail.
Don't forget the protective rubber caps.
11