Kegel IKON Lane Machine Operation Manual page 87

2. Drive Motor does not run.
a. Forward Relay is loose in socket or failed.
b. Reverse Relay is loose in socket or failed.
c. One of the motor control plugs is loose or unplugged. Check the speed
control and drive motor plugs.
d. Blown fuse.
e. Drive Motor or Speed Control has failed.
f. Go to the proper menu and check the operation of the relays.
3. Machine drives off into pit giving a Forward Travel Error.
a. DECEL set too slow on drive board.
b. Forward Cleaning Distance needs to be Decreased by the correct
number of counts.
c. Lane Distance shaft is not turning freely.
d. Lane Distance target is loose.
e. Lane Distance Proximity Sensor is too far from target.
f. Lane Distance Proximity Sensor is damaged.
g. Operator needs more training and is starting the machine too far past the
foul line.
h. Tail plank is missing from pin deck. Check for missing tail planks.
Q: If there is a definite failure of the Lane Distance Sensor is it possible to use
the TACH sensor for the LDS functions?
A: when the lane machine stops and displays the error message, you will have
the option to BYPASS SENSOR. This will allow you to get through conditioning
your lanes until you can address the problem. Once power has been removed,
you will need to press on the BYPASS SENSOR again.
74