Kegel IKON Lane Machine Operation Manual page 71

To lower the squeegee, apply power to the machine
and press MAIN MENU. Next, press the I/O TEST, and this
screen will pop up.
With the squeegee down, take a straight edge and
rest it on the squeegee blade across the main drive
wheels to the rear drive wheels. The gap between
the straight edge and the drive wheels should be
about 3/16" to 1/4" (3.18 mm to 4.76 mm) on each
side.
If the distance is more or less, loosen the bolts (two on each side) that hold the
squeegee pivot in place. Move the pivot mount until the squeegee height is correct.
This should be done for both the left and the right side. Tighten the bolts after the
adjustment is acceptable.
Press the SQU LIFT test button once. The squeegee
motor will activate and rotate 180°, this will lower
the squeegee. If the squeegee does not stop in
the down position, either you held the button too
long, or check the condition of the Squeegee
Down Switch.
Gap should be
3/16" to 1/4"
58