Fitting An Attachment - Nilfisk-Advance City Ranger 3500 Operator's Manual

2.2 Fitting an attachment

Connecting and removing attachments
The engine must always be turned off before the
attachment is connected/disconnected.
The couplings and the area around the couplings must be
kept clean to avoid an accumulation of dirt.
Fitting a front attachment
To fit or remove a front attachment, refer to the operator's
manual for this attachment. (Picture 1)
Make sure that the control panel matches the attachments
fitted on the vehicle.
Attention!
!
With a heavy attachment at the front of
the City Ranger 3500 (eg: third brush,
mower, snow sweeper), always drive
carefully and take into account that there
is a loss of grip on the rear wheels.
When the electrical connector is not connected, plug in
the protection cover. (Picture 2)
Fitting a rear attachment
To attach or remove a rear attachment, refer to the
operator's manual for the attachment. (Pictures 3 + 4)
Make sure that the control panel matches the attachments
installed on the vehicle.
When the electrical connector is not connected, plug in
the protection cover. (Picture 4)
Operator's Manual City Ranger 3500
Operator's manual
1
Front coupling
2
Protection cover
3
Rear safety bridle
4
Rear hydraulic couplings
Hydraulic couplings
Protection cover
31