Hydraulic Oil - Nilfisk-Advance City Ranger 3500 Operator's Manual

3.3 Hydraulic oil

Checking the hydraulic oil level
1. Turn the vehicle towards the left, stop the vehicle then
open the radiator screen. (Picture 1)
2. Remove the coolant tank to see the gauge. (Picture 1)
3. The hydraulic oil level should be between the black and
the red lines. (Picture 2)
4. If necessary, fill the hydraulic oil tank by connecting a
pump to the connector located at the rear of the vehicle.
(Picture 4)
Change of hydraulic oil
1. Park the City Ranger 3500 on a level surface.
2. Remove the oil drain plugs in order to allow the oil to
drain in a drain pan. (Picture 3)
3. After drainage, clean the oil drain plugs and put them
back with new gasket.
4. To refill, connect a pump to the return coupler at the
rear of the vehicle. (Picture 4)
Attention!
!
No other refill method is permitted
since the hydraulic oil must pass
through the vehicle filter to prevent any
contamination of the hydraulic system.
Operator's Manual City Ranger 3500
Service and maintenance
1
Radiator access door
2
Hydraulic oil level
3
Hydraulic oil drain plugs
4
Return coupler
Coolant
43