Nilfisk-Advance City Ranger 3500 Operator's Manual page 42

Service and maintenance
Change of engine oil and oil filter
NB: Drain the crankcase with warm oil.
Attention!
!
Hot oil and hot components can cause
personal injury. Do not allow hot oil or hot
components into contact with your skin.
1. Park the City Ranger 3500 on a level surface.
2. Open the filler cap. (Picture 1)
3. Remove the oil drain plug in order to allow the oil to
drain in a drain pan. (Picture 2)
4. After drainage, clean the oil drain plug and put it back
with a new gasket.
5. Remove the oil filter with a suitable tool.
6. Clean the sealing surface on the cylinder block.
7. Apply clean engine oil to the new oil filter seal and then
install a new oil filter and tighten it by hand. (Picture 3)
8. Fill with new motor oil (approx. 8 litres) until the level
reaches the maxi. on the dipstick, without exceeding it
and close the filler cap. (Picture 4)
Attention!
!
Never exceed the maxi. on the dipstick, it
could damage your engine.
42
1
Engine oil filler cap
2
Engine oil drain plug
3
Oil filter (bottom view)
4
Mini.
Operator's Manual City Ranger 3500
Maxi.