Setting Water Softening System; Special Salt - IKEA PROFFSIG Manual

Note: Set the water hardness determ-
ined on your appliance.
→ "Setting water softening system",
Page 27
With a water hardness of 0 - 8 °E you
can dispense with special salt and
switch off the water softening system.
→ "Switching off water softening system",
Page 28
Setting water softening sys-
tem
Set the water hardness on your appli-
ance.
Determine the water hardness and
1.
the appropriate setting value.
→ "Overview of water hardness set-
tings", Page 26
Press ⁠ .
2.
Hold programme button A and press
3.
repeatedly until the display
shows H:xx.
Release programme button A and
4.
⁠ .
Programme button A flashes and the
a
display shows H:04.
Press programme button C re-
5.
peatedly until the right water hard-
ness has been set.
Press to save the setting.
6.

Special salt

You can use special salt to soften water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser for
special salt just before the programme
starts. The amount of special salt re-
quired depends on the water hardness:
the higher the water hardness, the
greater the amount of special salt re-
quired.
ATTENTION!
Detergent may damage the water
●
softening system.
Only fill the dispenser of the water
●
softening system with special dish-
washer salt.
Special salt can damage the tub due
●
to corrosion.
To make sure that any special salt
●
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser for
1.
special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for dish-
3.
washers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dispenser.
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dispenser is
displaced and forced out.
Place the lid back on the dispenser
4.
and turn to close.
27
a