IKEA PROFFSIG Manual page 50

FAULT
Water marks on plastic
parts.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the door.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
CAUSE
Due to laws of physics
droplet formation on
plastic surfaces is un-
avoidable. After drying
water marks are vis-
ible.
Detergent substances
are deposited there.
These coatings cannot
generally be removed
with chemicals.
White coating is depos-
ited in the appliance in-
terior.
Special salt dispenser is
not screwed tight.
Detergent substances
are deposited there.
These coatings cannot
generally be removed
with chemicals.
The hardness range is
set incorrectly or the
water hardness is
greater than 62 °E
(8,9 mmol/l).
3in1/organic/eco deter-
gent is not effective
enough.
TROUBLESHOOTING
Select a more intensive pro-
●
gramme.
Position tableware at an
●
angle.
→ "Arrange tableware",
Page 34
Use rinse aid.
●
→ "Rinse aid", Page 29
Set the water softening sys-
●
tem higher.
Change your detergent
●
→ Page 30.
Clean the appliance mechan-
●
ically.
Set the water softening sys-
1.
tem correctly.
In most cases you will need
to increase the setting.
Change your detergent if re-
2.
quired.
Screw the special salt dis-
●
penser tight.
Change your detergent
●
→ Page 30.
Clean the appliance mechan-
●
ically.
Set the Water softening sys-
●
tem → Page 26 to the water
hardness or add special salt.
Set the Water softening sys-
●
tem → Page 26 to the water
hardness and use separate
detergents (proprietary de-
tergent, special salt, rinse
aid).
50