Error Code / Fault Display / Signal - IKEA PROFFSIG Manual

FAULT
Appliance door does
not open at the end of
the Eco 50° pro-
gramme.
Appliance door auto-
matically opens too
wide at the end of the
Eco 50° programme.

Error code / Fault display / Signal

FAULT
E:07 lights up.
E:12 lights up.
E:14 lights up.
E:15 lights up.
E:16 lights up.
E:18 or indicator for
water supply lights up.
CAUSE
The safety device will
switch Eco drying off.
Door is not correctly
adjusted.
Wrong screws used to
adjust the door gap.
CAUSE
Intake opening is
covered by items of
tableware.
Appliance has detected
calcified heating ele-
ment.
Water protection sys-
tem is activated.
Water protection sys-
tem is activated.
Water is continuously
running into the appli-
ance.
Supply hose is kinked.
Water tap is turned off.
Water tap is jammed or
furred up.
TROUBLESHOOTING
If the screws used here are
too long, this may deactivate
Eco drying.
Call Customer Service.
●
Adjust the appliance door as
●
described in the installation
instructions.
The door gap must be at
least 70 mm - 100 mm.
Use size 4X30 screws to ad-
●
just the door gap.
The screws are included in
the scope of supply.
If the screws used here are
too long, this may deactivate
Eco drying.
TROUBLESHOOTING
Descale the appliance.
1.
Operate the appliance with
2.
the Water softening system.
Turn off the water tap.
1.
Call Customer Service.
2.
Turn off the water tap.
1.
Call Customer Service.
2.
Turn off the water tap.
1.
Call Customer Service.
2.
Install the supply hose
●
without kinks.
Turn on the water tap.
●
Turn on the water tap.
●
44