3. Preparing the Scanner for an Inspection
Several connections and adjustments must be made to prepare the HSMT-Flex
scanner for an inspection.
To prepare the scanner for an inspection
1.
Position the scanner on or near the part to be inspected.
2.
Attach the umbilical cable or a safety line to the attachment ring (see Figure 3-1 on
page 37).
Figure 3-1 Attach the umbilical cable to the attachment ring
The attachment ring serves two purposes: when used to attach a safety line, it retains
the scanner in case of an accidental fall; and when used to attach an umbilical, it
prevents tension loads on cables and tubes.
3.
Connect the appropriate cables to the probes.
DMTA034-01EN, Rev. B, March 2014
Preparing the Scanner for an Inspection
37