cetis TeleMatrix 9700 Series User Manual page 29

This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules . These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation . This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications . However, there is no
guarantee that interference will not occur in a
particular installation .
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna
for the radio or television that is receiving the
interference) .
– Reorient or relocate and increase the
separation between the telecommunications
equipment and receiving antenna .
– Connect the telecommunications equipment
into an outlet on a circuit different from that to
which the receiving antenna is connected .
FCC RF Radiation Exposure
Statement
The installation of the base unit should allow
at least 20 centimeters between the base
and persons to be in compliance with FCC RF
exposure guidelines . For body-worn operation,
the portable part (handset) has been tested and
meets FCC RF exposure guidelines .
This device must not be co-located or operating
in conjunction with any other antenna or
transmitter . The changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment .
9700 SERIES VOIP USER GUIDE: CETIS SIP 2020 M SERIES VOIP USER GUIDE: CETIS SIP 2017
Industry of Canada
Requirements
Note: This equipment meets the applicable
Industry Canada Terminal Equipment Technical
Specifications . This is confirmed by the registration
number .
registration number signifies that registration was
performed based on a Declaration of Conformity
indicating
specifications were met . It does not imply that
Industry Canada approved the equipment .
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company . The equipment must also be installed
using an acceptable method of connection . The
customer should be aware that compliance with
the above conditions may not prevent degradation
of service in some situations .
Repairs to certified equipment should be coordinated
by a representative designated by the supplier .
Any repairs or alterations made by a user to this
equipment, or equipment malfunctions, may give
the telephone communications company cause to
request the user to disconnect the equipment .
Users should ensure for their own protection, that
the electrical ground connections of the power
utility, telephone lines, and internal metallic
water pipe system, if present, are connected
together . This precaution may be particularly
important in rural areas .
Caution: Users should not attempt to make such
connections themselves, but should contact
the appropriate electric inspection authority, or
electrician, as appropriate .
Notice: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an
indication of the maximum number of terminals
allowed to be connected to a telephone interface .
The termination on an interface may consist of
www.teledex.com www.telematrix.net
The abbreviation, IC,
that Industry Canada
before the
technical
29 29