3.2 Network Settings
You can get your network information from this
page:
3.2.1 WAN SETTINGS
WAN port network settings page can be used to
configure network access settings . Some vendors
call it the network port . This port is used to power
(POE) and connect the phone to the network .
Supports static IP, DHCP (to obtain dynamic IP
address), and PPPoE .
3.2.2 BASIC SETTINGS
Basic Setting
Network Mode
Select WAN port network
mode . Default is DHCP .
Link Mode
Auto is default .
Primary DNS
Set the primary DNS IP
address .
Secondary DNS
Set the secondary DNS IP
address .
14
14
3.2.3 DHCP
If there is a DHCP server in your local network,
the phone will automatically obtain WAN port
network information from your DHCP server .
3.2.4 STATIC IP SETTINGS
If you wish to set the phone to a static IP address,
configure the IP address, subnet mask, and
gateway here . DNS servers configured under
Basic Settings will be used .
Static IP Setting (Required if Network Mode Is
Set to Static IP)
Static IP Address
Subnet Mask
Default Gateway
3.2.5 PPPOE SETTINGS (POINT TO
POINT PROTOCOL OVER ETHERNET)
PPPoE Setting (Required if Network Mode Is
Set to PPPoE)
User Account
Password
3.2.6 802.1X SETTINGS
802.1x Settings
802 .1x_Enable
802 .1x_UserName
9700
www.telematrix.net
www.teledex.com
Set static IP address .
Set network mask of static
IP .
Set default gateway IP
address of static IP .
Set your PPPoE user
account .
Set the password of your
PPPoE account .
Enable or disable 802 .1x
authentication .
802 .1x User name .
SERIES VOIP USER GUIDE: CETIS SIP 2020
M SERIES VOIP USER GUIDE: CETIS SIP 2017