cetis TeleMatrix 9700 Series User Manual page 27

8 . **33*password#, (** DE*123 #) clears
the phone current configuration, resets to
default settings, and reboots automatically .
9 . **77*password*config ID#, the phone
downloads a new specified configuration
file from the TFTP server . After
downloading successfully, ignoring the
config file version number, the phone will
restart automatically .
10 . **87*password*VLANID#,
(** VS*123*newVLAN #) revises the
phone's VLAN ID . After revising the VLAN
ID successfully, it announces the new
VLAN ID and restarts the phone .
Example: Set the VLAN ID . Use value of 0
to turn off/disable VLAN .
Example: * * 8 7 * 1 2 3 * 0 # will disable
VLAN and should allow the phone to
receive a DHCP address from the local
network segment . Any other valid number
for a VLAN ID (1-4095) will set the VLAN ID
to that number .
11 . **89*<keypad password>*<TFTP server IP
address>*<ConfigID>#,
Example: **89*<123>*<10 * 0 * 0 * 100>*
<ConfigID>#,
The phone downloads the specified
configuration file <ConfigID> from the
TFTP server at specified IP address
(10 .0 .0 .100) . After downloading
successfully, the phone will apply the file
and restart automatically .
M SERIES VOIP USER GUIDE: CETIS SIP 2017 9700 SERIES VOIP USER GUIDE: CETIS SIP 2017
12 . SF - **73*<kp># Set Network Mode to
Fixed - Necessary before setting a phone
to Static IP . For Example: **73*123#
13 . SI - **74*<kp># Set Static IP - After
setting the Network mode to fixed, set the
phone to a Static IP **S(7)I(4)*123*IP#
Example: **74*123*192*168*10*1# -
would set the static IP to192 .168 .10 .1
14 . SN - Set Sub net : - **76*<kp># **S(7)
N(6)*123*SN#
- Example: **76*123*255*255*0*0# -
would set the subnet to 255 .255 .0 .0
15 . GW - Set Gateway : - **49*<kp>#
**G(4)W(9)*123*GW# - Example:
**49*123*192*10*10*1# - would set the
Gateway to 192 .10 .10 .1
NOTE: You must power cycle/reboot phone
after manually changing IP address using
codes .
16 . GK - Set Guest Keys/Speed Dials from
the Dial pad **45*1002*M1#
K(5) * (Speed Dial Number) * press the
Guest Key (M1~M10) # (press # to
terminate function) .
17 . LO - **56# (In firmware 3 .0 .0-053 and
higher) LLDP ON/OFF Toggle LLDP
Enable/Disable (useful in some situations
where LLDP Negotiations fail) .
18 . **99 – Toggle ON/Off Auto-Reboot: Phone
will reboot (or not) if it cannot register
after 3 minutes .
www.teledex.com www.telematrix.net
** G(4)
27 27