Delete Handset; Switch Between Base; And Handset; Switch Between Line - cetis TeleMatrix 9700 Series User Manual

flash, indicating the handset is in register mode;
the ON/OFF light on the handset flashes at the
same time . If the handset registers successfully
to the base, then the Message light on the base
and the ON/OFF light on the handset will stop
flickering and will give the prompt tone for a
successful registration .
Note: Each base phone can register up to 5
handsets.

2.1.11 DELETE HANDSET

Hold down the page key until the MWI light starts
blinking, then release the page key and press it 7
times . After this the MWI light should start blinking
rapidly . After the page light as stopped blinking
rapidly, all handset registrations should be deleted .
2.1.12 SWITCH BETWEEN BASE AND
HANDSET
When a call is active on the base phone, press
the Line 1 or Line 2 handset key and the handset
will pick up the active call . If a call is active on
the handset, press the Line 1 or Line 2 key on the
base to switch the conversation to the base .
2.1.13 SWITCH BETWEEN LINE 1 AND
LINE 2
When Line 1 is on Hold and Line 2 is active, press
the Line 1 key, and Line 1 will no longer be on
Hold—Line 2 is now on Hold . If Line 2 is on Hold
and Line 1 is active, press the Line 2 key for Line
2 to resume and for Line 1 to be placed on Hold .
2.1.14 BASE PHONE AND
CORDLESS HANDSET CAN MAINTAIN
INDEPENDENT CONVERSATIONS
The base phone and the cordless handset can
maintain conversations independently, with true
two-line functionality . For example, Line 1 can
place a call from the base phone to one phone
destination while Line 2 from the cordless
handset can be active to a separate destination .
9700 SERIES VOIP USER GUIDE: CETIS SIP 2020 M SERIES VOIP USER GUIDE: CETIS SIP 2017
3. Web Interface
Settings
Connect both the phone and your PC on the same
LAN (Local Area Network), open the browser and
enter the IP address of the phone . The browser
will ask you to enter the username and password .
Please enter the username and password as
to login . Default username and password are
admin/admin .
3.1 Home Page—Summary of
Network Parameters
After entering the username and password, the
following screen is displayed:
www.teledex.com www.telematrix.net 13 13