Table of Contents
Advertisement
"One Touch" Operation*
Push the switch downward to auto down
position and then release to open the win-
dow fully.
When the window is moving down automat-
ically:
The window will stop moving down if the
switch is pushed down to manual or auto
down position and released again.
The window will move up if the switch is
pulled up to the manual up position.
The window is also equipped with the func-
tion to open or close the window by one
touch. Press and hold the lock button on the
remote transmitter for more than 2 seconds,
the four windows can move up to the fully
open position at the same time.
Locking of Rear Window
The rear window lock button
on the driver door, next to the window
switch. Press this button to disable the rear
window operation. This indicator on the but-
ton will illuminate to indicate that this func-
tion is activated. When the lock function is
activated, the rear window can still be
moved up or down by operating the driver
window switch. To restore the power opera-
tion of the rear window, press this button
again. The indicator on the button will also
go off.
Power window thermal protection
If the windows are operated repeatedly in a
short time, the power window control switch
might be disabled for ensuring service life of
the motor. To restore power window opera-
tion, users have to wait for a moment.
Anti-pinch Function*
The window will stop closing halfway auto-
matically and returns to its original state if
something gets jammed between the glass
and window frame during auto close opera-
tion. If the window suffers a strong impact,
this function may operate even if nothing is
caught. If the power window can not oper-
ate automatically or the anti-pinch function
can not operate normally, initialize the
power window.
Anti-pinch Power Window Learning*
If the vehicle battery is recharged, discon-
nected or does not operate normally, it is
necessary to perform learning for the power
window with anti-pinch function again to
use one touch operation function.
Replace or recharge the vehicle bat-
is located
tery before learning is performed.
The learning steps are as follows:
1.
Pull the switch up to manual up position
until the window glass fully moves to the
top. Pull the switch up again, hold for 1
second and then release it.
2.
If the rear power window still can not
operate normally after operating as
shown
repaired by the Geely Service Station.
Delay operation functions
After the ignition switch turned off, press
and hold the lock button on the remote key
for 2 seconds to operate this function if all of
the following 3 conditions are met.
1.
Within 45 seconds after the ignition
switch turned off;
2.
All of the doors, engine hood and lug-
gage compartment are closed;
3.
The anti-theft system does not set off an
alarm.
39
Instrument and Controls
above,
have
your
1
2
3
4
5
vehicle
6
7
8
Advertisement
Table of Contents
