Table of Contents
Advertisement
When there is an open fire near the
battery, it may cause the gas in the
battery to explode. Some people have been
hurt for the reason, and some have lost
their sight. If the light is insufficient, please
use your flashlight. The acid liquor in the
battery may burn you. Never make the acid
liquor splash on you. If the acid liquor acci-
dentally splashes into your eyes or on your
skin, please wash it at once and see a doc-
tor.
The fan and other moving parts of the
engine may seriously hurt people.
When the engine is running, be sure to
keep your hands away from the moving
parts of the engine.
2.
Connect the one end of the red posi-
tive(+) cable to the positive(+) binding
post (A) of the vehicle to be started in
the Jump Starting way.
3.
Do not connect the other end of the red
positive(+) cable to the metal. Connect
it to the positive terminal (+) of the bat-
tery (B).
4.
Connect the one end of the black nega-
tive (-) cable to the negative(-) terminal
of the battery (C) Do not make the other
end contact anything before proceed-
ing to the next step. Do not connect the
other end of the negative (-) cable to the
battery without power, but connect it to
the unpainted metal part of the engine
of the vehicle with the no-power battery.
5.
Connect the other end of the negative (-
) cable to the unpainted metal part (D)of
the engine of the vehicle with the flat
battery, but keep it away from the mov-
ing parts of the engine and battery.
6.
Start the engine on the vehicle with
booster battery and keep it idle for four
minutes or more.
Try to start the vehicle with the flat battery. If
the vehicle is not started after several tries,
the vehicle probably needs to be repaired.
If you connect or dismantle the
jumper cables in a wrong order, it
may cause the short circuit and do damage
to the vehicle. The resulting maintenance is
not covered under the warranty. Therefore,
be sure to connect or dismantle the jumper
cables in a right order and make sure that
the cables will not contact each other or
other metals.
If you want to disconnect the jumper cables
on the vehicle:
1.
Disconnect the black negative (-) cable
on the vehicle with flat battery.
2.
Disconnect the black negative (-) cable
on the vehicle with booster battery.
3.
Disconnect the red positive(+) cable on
the vehicle with booster battery.
4.
Disconnect the red positive(+) cable on
the vehicle with flat battery.
147
In an Emergency
1
2
3
4
5
6
7
8
Advertisement
Table of Contents
