Geely Emgrand 2015 Manual page 120

Table of Contents

Advertisement

Starting and Driving
2.
If the engine can't be started within
5~10
seconds,
weather (under -18 ° C), it may be the
result of too much gasoline poured into
the engine. Try to fully press the accel-
erator pedal and hold it. At the same
time, press the ignition switch button for
1 to 2 seconds. The start time interval
should be at least 15 seconds to cool
down the starter. After starting the
engine, please release the accelerator
pedal. If the vehicle is started and then
turned off at once, please implement the
same operations. In this way, the extra
gasoline in the engine can be cleaned
up. Don't increase the engine speed
immediately after starting the engine.
Gradually operate the engine and the
transmission so that the engine oil can
be preheated and lubricate all working
parts.
Backup Starting Procedure of Vehi-
cle
When the vehicle is in a strong signal inter-
ference region, and the power of the key
remote control battery is insufficient, or the
keyless start function fails, if you try to start
the vehicle and press the ignition switch
button, the instrument cluster may prompt
"Not Detect Smart Key", by this time you
can't start the vehicle through press-button
type start procedure.
Please follow the steps below to start the
vehicle:
1.
Keep the remote control as close as
possible to the ignition switch button.
2.
press the clutch pedal (MT) or the brake
pedal (CVT).
3.
Press the ignition switch button to start
the engine.
especially
in
cold
Scope of application of the standby
start procedure:
The key remote control batteries use up
and are not replaced in time.
When the vehicle is in a strong signal
interference, you can get the vehicle off
this zone through the use of standby
start procedure so as to restore the nor-
mal function of the keyless start proce-
dure.
After replacing the batteries and getting the
vehicle off the interference zone, if the key-
less start procedure still cannot be in nor-
mal use, please go to the Geely Service
Station for maintenance.
If Engine Fails to Start
Before inspection, be sure to start the vehi-
cle in accordance with the correct start pro-
cedure in the "Starting Engine"section, and
confirm whether there is enough fuel.
Even if your vehicle is equipped with the
electronic anti-theft system, you also need
to check whether other keys can also start
the engine. If other keys can start the
engine, your keys may go wrong. Hand
over your keys to the Geely Service Station
for maintenance. If all your keys fail to start
the engine, the system may have a mal-
function. Please contact the Geely Service
Station for maintenance.
118

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emgrand 2016Emgrand 2017Emgrand 2018Emgrand 2019

Table of Contents

Save PDF