G2 Adjustment; Start Up The G2 Adjustment; Adjusting The G2 - Barco CINE7 Installation Manual

6. G2 ADJUSTMENT

6.1 Start up the G2 adjustment

Start up
1. Enter the adjustment mode by pressing ADJUST. (menu 6-1)
2. Highlight Service.
3. Press ENTER to start up the service mode.
4. Highlight Common settings. (menu 6-2)
5. Press ENTER.
6. Highlight G2 adjust. (menu 6-3)
7. Press ENTER.
A safety notice will be displayed to warn the operator. (menu 6-4)
If you are qualified, press ENTER to continue with the G2 adjustment, otherwise press EXIT to return to the service menu. If
ENTER is pressed, the G2 menu will be displayed (menu 6-5)
ADJUSTMENT MODE
Select a path from below :
IRIS
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-1
G2 ADJUSTMENT
RED
ABL: ON
Select color with ← or →
<ENTER> to toggle ABL
<EXIT> to return
Menu 6-5

6.2 Adjusting the G2

How to adjust
1. Open the top cover to reach the G2 controls for red, green and blue. (image 6-1)
While starting the G2 control, the controller will automatically increase brightness and contrast until the raster behind the displayed
text becomes visible.
2. Look to the projected image and observe the raster behind the image while the ABL function is ON.
3. Switch ABL to OFF by pressing ENTER and adjust the G2 control until the raster brightness looks the same as when the ABL
function is ON.
4. Check the correct raster adjustment by pressing ENTER to toggle ABL to ON. Repeat these steps if necessary.
5. Continue wiht the other colors. Use the right or left arrow to select the next color.
R5976585 BARCO CINE7 26022003
SERVICE MODE
PROJECTOR SET UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-2
COMMON SETTINGS
G2 ADJUSTMENT
CRT RUN IN CYCLE
PROJECTOR WARM UP
MEMORY BANKS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-3
6. G2 Adjustment
SAFETY
NOTICE
RISK OF ELECTRICAL SHOCK
G2 ADJUSTMENT SHOULD
BE PRERFORMED BY BARCO
AUTHORIZED DEALERS
IF QUALIFIED, PRESS
<ENTER> to continue,or
If not, <EXIT> to return.
Menu 6-4
29