3. Installation Guidelines
Check procedure
This check procedure can only be done after power (mains) connection. So, first continue with the projector set up and the connec-
tions and then return to this checking procedure.
1. Switch on the projector
2. Press ADJUST to start up the adjustment mode. (menu 3-1)
3. Push the cursor key ↑ or ↓ to select Service and press ENTER.
The service menu will be displayed. (menu 3-2)
4. Push the cursor key ↑ or ↓ to select PROJECTOR SET UP and press ENTER.
The projector set up menu will be displayed. (menu 3-3)
5. Push the cursor key ↑ or ↓ to select IDENTIFICATION and press ENTER.
The Identification screen will be displayed. (menu 3-4)
On this screen, information is given about the projectors configuration. Configuration when leaving the factory : ceiling/front
configuration.
ADJUSTMENT MODE
Select a path from below :
IRIS
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 3-1
16
SERVICE MODE
PROJECTOR SET UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 3-2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 3-3
R5976585 BARCO CINE7 26022003
BARCO
CINE 7
Proj.
address:
001
Soft.
Version:
2.11
Config.:
Ceiling
Front
Baudrate PC: 9600
Text:
ON
Serial No.:
1035895
Menu 3-4