Commissioning; Mounting; Attaching The Power Supply Unit; Installing The Bar Clips - Beckhoff CX2100-0014 Manual

Commissioning

5 Commissioning
5.1

Mounting

This chapter describes how to install the power supply unit CX2100-0014. This documentation uses the
Embedded PC CX2020 to demonstrate the procedure.
5.1.1

Attaching the power supply unit

The power supply unit CX2100-0014 supplies power to Embedded PCs of the CX2000 series. The power
supply unit and the Embedded PC are connected via the multi-pole connector.
Proceed as follows:
1. Plug the power supply unit into the high-pole connection on the right on the basic CPU module.
2. Check whether the power supply unit is flush with the Embedded PC.
ð In the next step, you can install the bar clips.
5.1.2

Installing the bar clips

Usually, the connection between the modules is strong enough. However, the basic CPU module and the
attached modules may be subjected to shocks, vibrations or other impacts. The modules can be securely
connected to one another with the aid of bar clips.
Install the bar clips as follows:
1. Attach the bar clips at the top and bottom between the cooling fins.
2. Push the bar clips between the cooling fins of your devices, as shown in the image below.
14 Version: 1.2 CX2100-0014