Table of Contents
Advertisement
3.
Equipment preparation
This section details the preparation to the P571 flexicoiler which is necessary prior to commencing the
survey. Most of the checks are to ensure that the equipment is safe to use. Other checks, if carried out
correctly, will ensure that the equipment operates correctly during the survey.
2.3.1 P571 preparation
WARNING: Risk of explosion.
Do not use the P571 flexicoiler if there is damage to the body or any other part. The certification may be
violated rendering the equipment unsafe to use in a hazardous environment. Contact your Pearpoint
representative immediately.
WARNING: Risk of injury.
Heavy duty gloves and safety goggles should be worn when handling rod. Any abrasions or damage on the
rod outer covering can cause injury to unprotected hands.
Figure 2.1 P571 flexicoiler - Preparation
Check the power cable (Item 1) for damage and security. If the cable or plug is damaged in any
1.
way it must be replaced.
Inspect the frame (Item 2) to ensure that there is no damage or distortion. Inspect all welds for signs
2.
of cracking. If any damage is apparent, contact your Pearpoint representative for advice.
Check the condition of the hub connector. Ensure it is secure and not damaged or dirty. If the
3.
connector has been damaged, contact your Pearpoint representative for advice.
Remove all rod from the coiler and inspect for damage. If the rod is damaged, water may leak
4.
through the outer covering and damage the equipment. Contact your Pearpoint representative
for advice.
NOTE: It is also necessary to calibrate the rod before use. This will ensure that the rod counter will give
accurate measurements. See Section 3 for details.
10
Advertisement
Table of Contents
