Disinfecting Surfaces; Cleaning Surfaces; Cleaning Handle In; Sterilizing Handle In - Cheyenne HAWK Operating Instructions Manual

• Aromatic/halogenized fluorocarbons
(e.g. phenol, chloroform) as well as
• acetone and benzene
7.2

Disinfecting surfaces

Before and after each usage:
Disinfect all surfaces of the tattooing
E
machine and its accessories as
described in chapter "5.1 Disinfecting
equipment" on page 39.
7.3

Cleaning surfaces

In the event of external contamination:
Disassemble the handle and drive.
E
Wipe the handle and drive –
E
especially the piston – and the long
protective sleeve with a soft cloth
moistened with a cleaning agent or a
disinfectant.
Clean inaccessible surfaces, e.g.the
E
thread of the handle and drive unit,
with a soft-bristled nylon brush or
cotton swab.
Note that due to the matte surface,
E
streaks of
the tattooing machine.
48
ink may occur
Cheyenne HAWK, HAWK SPIRIT & HAWK THUNDER
7.4 Cleaning handle in an ultrasonic
bath
If the handle is severely soiled:
Use cleaning agent Tickomed 1 or
E
Tickopur R33 from manufacturer
Dr. H. Stamm GmbH in accordance
with the manufacturer's instructions.
Make sure that a pH value of 7 is not
exceeded.
Conduct the cleaning operation for
E
10 minutes at a frequency of 35 kHz.
Dry the handle fully after cleaning,
E
before you use it again.
7.5

Sterilizing handle in

an autoclave

Whenever handle is contaminated:
Perform all steps described in
E
chapter "5.1 Disinfecting equipment"
on page 39.
Autoclave the handle for 20 minutes
E
at a temperature of 121°C and a
pressure of 2 bar.
Dry the handle fully after cleaning,
E
on
before you use it again.