Setting The Piercing; Loading With Ink; Cleaning And Maintaining The Tattooing Machine; Frequency - Cheyenne HAWK Operating Instructions Manual

6.2 Setting the piercing frequency
Risk of injury due to high piercing

frequency

If the piercing frequency is too high,
the skin can be cut.
Always start at a low piercing
E
frequency, e.g. 70.
Switch on the power supply of
E
the Cheyenne power unit.
Set an appropriate piercing frequen-
E
cy.
The piercing frequency can be
adjusted in 10 increments using
the arrow keys. The piercing frequency
must suit the characteristics of
the customer's skin, the needle
protrusion and piercing depth when
working, as well as the operating
speed.
6.3

Loading with ink

Immediately before use, dip the tip
E
of the safety cartridge in the desired
color of ink for 2 to 3 seconds with
the unit running. Avoid contact with
the ink container.
The ink is picked up by the needles.
46
CAUTION
Cheyenne HAWK, HAWK SPIRIT & HAWK THUNDER
Alternatively, the ink can be filled into
E
the opening on the safety cartridge
using a sterile pipette. Never fill in
too much ink so that it is not ejected
through the opening.
7 Cleaning and maintaining
the tattooing machine
CAUTION
Risk of short circuits and risk of mild
electric shocks
If components
machine are dismantled and cleaned
while still powered, there is a risk of
mild electric shock and damage to
the electronics in the drive unit.
Switch off the voltage supply to
E
the tattooing
you begin with cleaning and
maintenance work.
of the tattooing
machine before