Operating The Boom Control On Saritor; Boom Tilt Function; Alternative Boom Widths - Hardi BOOM TERRA FORCE Instruction Book Supplement

Hide thumbs Also See for BOOM TERRA FORCE:
Table of Contents

Advertisement

Operating the boom control on Saritor

To fold the boom
±
WARNING! Carefully follow steps below in order. Failure to do so may damage the boom and sprayer.
±
ATTENTION! The centre locks automatically when pressing 2nd outer folding button.
±
WARNING! Confirm the centre is locked before folding continues.
1. Press and hold buttons (4) to automatically set the centre to
horizontal position (AutoTerrain only). If not equipped with
AutoTerrain use button (E) and (F), until the centre is horizontal.
2. Press button (2) to lock the centre. The symbol
display until pendulum is locked. This takes approximately 10
seconds.
3. On the grip press the boom lift button (H) to raise the boom to
the highest possible position.
4. On the console press and hold the button (5) to fold the 2nd
outer wing until it it's resting on the wing support.
5. On the console press and hold the button (4) to fold the 1st outer wing until it it's resting on the wing support.
6. On the grip press button (A),(B),(H) and (C) tilt wings to around10 degree angle
7. On the console press and hold the button (3) to fold the inner wing until the boom touch the side post. Make sure the
wings will clear the transport brackets, if not press button (A) and (C) to tilt the boom up.
8. On the grip press and hold button (B) and (D) to tilt boom down
into the transport rests
9. On the grip press button (I) to lower the centre until the paralift
transport locks engage.

Boom tilt function

The tilt buttons (A),(B) (C), (D) can individually change the inclination of the boom wings.

Alternative boom widths

The boom can also be used partially-folded. If applicable, only unfold the inner wing or inner and 1st outer wing sections.
On the grip unit make sure to deactivate spray sections, that should not be used.
±
WARNING! When using the boom partially folded there is no active break-away section. Therefore any contact on the
end of the boom will damage the boom.
appears in
A
B
E
I
5 - Operation
H
C
D
F
G
47

Advertisement

Table of Contents
loading

Table of Contents