Led Status Indicators; Connecting The Camera To The Pc - Mobius Maxi User Manual

LED status indicators

The following LED states are for a camera not connected to the PC.
○
Steady Yellow - The camera is in Video Mode 1 and is on standby.
☼
Slowly flashing Yellow (1 sec. On, 1 sec. Off) - The camera is in Video Mode 1
and is recording video. The Video Recording indicator (see configuration) must
be ON for this to work.
○
Steady Blue - The camera is in Video Mode or Playback Mode (if an A/V cable is
connected) and is on standby.
☼
Slowly flashing Blue (1 sec. On, 1 sec. Off) - The camera is in Video Mode 2 and
is recording video. The Video Recording indicator (see configuration) must be ON
for this to work.
○
Steady Red - The camera is in Photo Mode.
☼/☼
One Red/Yellow flash - The camera has taken a picture.
○ ○
/ Steady Blue and Yellow (together) - The camera is in Mode 1 or Mode 2 with AE
Lock and/or AWB Lock turned on. See below under "Additional Information".
☼/☼
Slowly flashing Blue and Yellow (together) - The camera is recording in Mode 1
or Mode 2 with AE Lock and/or AWB Lock turned on. See below under
"Additional Information".
☼/☼
Slowly flashing Yellow and Red (together) - The camera is recording in Mode 1
without recording Sound. See below under "Additional Information".
☼/☼
Slowly flashing Blue and Red (together) - The camera is recording in Mode 2
without recording Sound. See below under "Additional Information".
○
Steady Green - The battery is charging.
In some cases 3 LEDs will be on or blinking at the same time, for example AE/AWB lock
together with Audio recording turned off. Since the physical LEDs are not visible, it will
be very difficult to see which LEDs are turned on in these cases. If both the Red and
Blue LED are on at the same time the result will appear as purple.
The rear LED
If the camera is configured to show the Recording Indicator, then the rear LED will
normally blink in sequence with the main LED while recording or in standby mode.
► The rear LED will blink when WiFi mode is enabled and the camera is waiting for a
smart phone to connect. The top LED will be steady.

Connecting the camera to the PC

Make sure a card is inserted and the camera is turned OFF if you want to access the
camera as an external device (disk drive, setup). Always connect the camera directly to
the PC. Do not use a USB hub.
► You cannot record video or photos if the camera is connected to the PC as an
external drive.