Mobius Maxi User Manual page 6

Recording Video Mode 1 or 2 (yellow or blue LED)
Start video recording.
•
Briefly press the shutter button (top left).
•
► If the recording LED has been disabled, the yellow or blue LED will slowly
blink 3 times and then turn off, indicating that recording has started.
•
► If the recording LED has been enabled, the yellow or blue LED will slowly
flash at 2 second intervals indicating that the camera is recording.
Stop video recording.
•
Briefly press the shutter button (top left). The camera will return to the standby
mode from which the video was started.
Taking a Photo (red LED)
•
Briefly press the shutter button (top left). The red LED will flash indicating that a
picture was taken.
Removable Disk Mode
•
Make sure the camera is turned off and a memory card is inserted.
•
Connect the camera to the PC using a standard USB cable. The green LED may
turn on at the same time indicating that the battery is charging.
•
► If this is the first time you are connecting the camera to the PC the operating
system will attempt to install the iCatch drivers. This may take a few minutes.
•
The LEDs will blink and after a short while the red LED will turn on.
•
The camera is now in Disk Mode and a new removable drive should be available
on your computer. The above procedure may take up to 30 seconds.
•
► You cannot record video or photos if the camera is connected to the PC in
Removable Disk Mode.
USB Webcam Mode
► In Windows 10 you must ensure that programs have access to the Camera. The
Camera access settings can be found under 'Privacy' from the 'Settings' dialog. Click
the Windows Icon at the bottom left of the screen. Then click the Settings icon (Gear
icon) a little higher up on the left. This will bring up the Settings dialog from which you
should click 'Privacy' and then, on the left 'Camera'. Make sure that access to the
camera is turned on.
There are two ways in which you can enter webcam mode.
Method 1:
•
Remove the SD card and connect the camera to the PC.
•
The camera will connect in webcam mode.
•
► If this is the first time you are connecting the camera to the PC the operating
system will attempt to install the iCatch drivers. This may take a few minutes.
•
If the drivers were installed correctly the camera should now be in USB camera
mode.