Usb Connector; Before You Start - Mobius Maxi User Manual

Formatting
Standard formatting tools provided by the operating system are not always reliable and
should not be used. In addition, they do not optimize the SD card's performance.
For optimal card performance it is recommended to either use the Windows setup
program (mSetup, see below), the Android or iOS app (Mobius Maxi WiFi, see below),
or use the camera's built-in formatter. Instructions for In-Camera Formatting are outlined
below.
In-Camera formatting is also available via the OSD menu.
Another excellent formatting utility is "SD Formatter" which can be downloaded from
https://www.sdcard.org/downloads/formatter_4/index.html. This utility has been
specifically designed to format SD cards.
In-Camera Formatting
The Camera contains a built-in formatter which should be used to format the SD card.
1. Disconnect the camera and ensure it is turned off.
2. Turn on the camera and wait until it is in one of the Standby modes (steady
yellow, blue or red LED).
3. ► If the camera was set to auto-record, press the Shutter button (top left) to stop
the recording.
4. Press and hold down the Shutter button (top left).
button.
5. Very quickly press the Mode button (top right) 4 times.
6. ► If the LEDs don't start to blink, release the buttons and start over again at 4.
7. The LEDs will blink very quickly while the card is being formatted.
8. Release the Mode and Shutter buttons once the LEDs start to blink (see above).
9. The camera will return to Standby mode when the formatting is finished.

USB connector

The Mobius Maxi uses a 10 pin Mini USB connector. Although 10-pin, the connector is
compatible with all standard 5-pin mini USB cables for USB data transfer and charging.
Cables
The camera requires a standard (5-pin) USB cable for charging or connecting to
external battery packs for continuous recording. A standard (5-pin) USB cable is also
used to connect the camera to the PC in order to set the parameters or to access the
camera as an external disk.
A special 10-pin USB cable is required for A/V out (TV-Out, Video-Out).
You must under no circumstances use any other "special" cable, especially the "special"
cable supplied with the old #11 808 camera. Doing so will destroy your camera beyond
repair. So, do not use a #11 "special" cable under any
►Always use HIGH QUALITY USB cables. Cheap cables may lead to all sorts of
problems. If possible, keep the cable as short as possible.
►The Mobius Maxi uses the same 10-pin cable as the Mobius 2.

Before you start

Before using the camera for the first time, ensure the internal battery is fully charged.
See below under "Charging".
DO NOT RELEASE the
circumstances.