Mobius Maxi User Manual page 3

The Reset button
The reset button is in the small hole located on the right side in line with the center of
the Power Button (looking at the camera from the top with the lens pointing forward). It
can be pressed by carefully inserting a bent paper clip or similar instrument. The Reset
button should only be pressed in case the camera no longer reacts to button presses.
Pressing the Reset button will force the processor to restart. No parameter settings will
be lost and the RTC (Real Time Clock) will not be interrupted.
The Power button
Press the power button (large, round button in the top center) until the LEDs start to
blink. After a short while a steady yellow LED is shown. The camera is now ready for
use (standby).
•
To turn off the camera, first stop any recordings that may be running by pressing
the shutter button (top left) and then press the power button for about 2 seconds
until the camera turns off.
The Mode button
The Mode button (top right) enables the camera to be sequentially switched between 3
(4) different modes. Each button press advances to the next mode indicated by the LED
color.
•
Video Mode 1 (yellow LED). The frame rate and resolution can be individually
configured.
•
Video Mode 2 (blue LED). The frame rate and resolution can be individually
configured.
•
Photo Mode (red LED) which also includes Time-Lapse photos.
•
Playback Mode (blue LED) only when external monitor (Video-Out/TV-Out)
connected.
The Shutter button
Press the shutter button (top left) to start or end a video recording or to take a picture.
A word of warning
Never press the Power button together with the Shutter button. Doing so will set the
camera in a special 'USB firmware Recovery Mode' and the buttons will no longer react.
The only way to exit this mode is to press the Reset button using a small bent paper clip
or similar instrument.