Mobius Maxi User Manual page 8

4. On your phone, connect to the camera's WiFi which will be named
"MobiusMaxi_0559c8" or similar.
5. When the phone is successfully connected to the camera the rear LED will remain
on.
6. Launch the "MobiusMaxi WiFi" app and tap "Connect to Mobius".
The app will show a small live-view image from the camera. A full screen live-view
can be obtained by turning the phone 90° so it enters landscape mode (must be
enabled on your phone).
To set the parameters, select the correct Mode from the large Mode-Selector wheel
and then tap the settings (Gear icon) icon on the top right of the screen. To see all the
parameters, tap the "Advanced" button control on the top right of the settings screen.
The camera's parameter is immediately set when it is modified in the app.
After selecting the desired mode, press the large red button in the center of the Mode-
Selector wheel to start a recording. If Photo Mode has been selected, a photo is
taken. If a Video Mode has been selected then the video recording is started and WiFi
connection will be lost.
► There is a brief help available in the app for connecting the phone to the camera.
► All of the video settings except for the "Video size" are common to both video
modes, so changing one of the parameters in one video mode will also change the
setting in the other video mode.
► The app requires at least Mobius Maxi firmware V2.07 to run correctly.
3. Manual configuration using an external monitor
It is also possible to manually change the configuration settings by using the On
Screen Display (OSD) by connecting the camera to an external Monitor/TV. This
requires a special cable.
1. Disconnect the camera from the PC and turn it off.
2. Connect the camera to an external monitor/TV using the special cable.
3. Optional. You may also connect the USB plug to a power source. The camera
will automatically turn on.
4. Turn on the camera by pressing the Power button (large button in the top center)
until the LEDs begin to blink.
5. Long-press the Shutter button (top left) to enter OSD Menu Mode.
6. Briefly press the Shutter button (top left) to switch between Recording settings
and Basic settings. Ensure that no parameters are highlighted.
7. Briefly press the Mode button (top right) to move down the list or the Power
button (large button in the top center) to move up the list.
8. Briefly press the Shutter button (top left) to change a parameter value.
9. Use the Mode button (top right) or the Power button (large button in the top
center) to move down or up the list (see above).
10. Briefly press the Shutter button (top left) to select the value.
11. Long-press the Shutter button (top left) to exit OSD Menu Mode and return to
Standby Mode.
► The meaning of the different buttons are shown on the OSD. Up, Down, Enter
► In order to switch between Recording settings and Basic settings make sure no
parameters are selected. Use the appropriate buttons to move the selection up or
down to the top or the bottom of the list.
► Also see OSD (On Screen Display) Menu, below.