Huawei OptiX OSN 9560 Quick Installation Manual page 35

11
Installing CRPC Cables
CRPC
Cable for
communication
between the
CRPC and the
B
subrack
OptiX OSN 9560
NOTE
Connect working and protection CRPC power cables to the power ports on the CRPC and run them
upward along the cable area on the right side panel to the power cable terminal blocks at the top of the
cabinet top.
Insert one end of a straight-through cable to the LAN port on the CRPC and the other end to the ETH1 or
ETH2 on the SEI2 board on the OptiX OSN 9560 subrack.
Reserve 2U (89 mm) of space above the CRPC for heat dissipation. Ensure that air vents for the subrack
are not blocked.
A
MON SYS LINE
LAN
RS232 -1 RS232-2
32
Phillips screwdriver
Network management
CRPC power
cable
CRPC power cable
A
B
Connected to
the ETH1 port
cable