Installing Fibers - Huawei OptiX OSN 9560 Quick Installation Manual

Installing Fibers

1
Precautions for Installing Fibers
DANGER
Always wear protective glasses or goggles when you look directly at an optical port (Figure 1).
Coil fibers from other sites on the ODF and connect them to the local cabinet. Do not coil the fibers from other equipment rooms
in the local cabinet.
NOTE
When two or more cabinets stand side by side and their side panels cannot be removed, place fiber connectors into a plastic bag,
and pass the plastic bag into the cabinet through a cable hole at the top of the cabinet (Figure 2).
Figure 1
NOTE
Be careful not to damage fiber connectors when you install fibers.
After fibers are installed, cover unused optical ports with dustproof caps (Figure 3) and unused fibers with
fiber caps (Fiber 4).
Figure 3
Pluggable
optical module
NOTE
Do not load too many fibers into one open corrugated pipe. If fibers 2 mm in diameter are used, load a
maximum of 60 fibers into an open corrugated pipe 32 mm in diameter (Figure 5). About 10 cm of the
pipe should be secured inside the cabinet (Figure 6).
Figure 5
Fixed optical
module
Dustproof
cap
Fiber diameter: 2 mm
Number of fibers: 60
Figure 2
Side panel
Fiber cap
Connector
Fiber cap
37
Fiber
connector
Plastic
bag
Figure 4
Connector
Figure 6
10 cm