Maintance And Cleaning - Jolly X-7 Coupe User Manual

DANGER:Disconnect from the mains before starting any maintenance work.
Ballast
Please change timely when each pin is getting yellow.
Be sure to maintain the device every 2 months,and make sure that all parts of the ballast,such as,scre-
ws,terminals,are locked well to ensure performance.Neglecting of maintenance may lead to failure of
devices.
Lamp
Turn off the lamp first to better protect the device when the fixture is turned off. Turn off the power after
running for at least 5 minutes
Don't touch the bulb with your hands.Once contacting with your hands,scrub with alcohol and then dry
with linen.
When the light is on, the bulb runs at high pressure,so there is a risk of broken.It is related to the duration
of using,temperature and unreasonable operation.Therefore, please do not use lamp over the life span.
The using of lamp should not exceed
time of the fixure regularly.When the lamp is used around 1500 hours, We strongly recommend that you
change the lamp.After replacing it,the used time of lamp can be removed and reset.
Avoid operating in dirty and dusty environment, clean and maintain lamps regularly. Wipe the outside of
the lens at least every 20 days. Wipe the internal fan at least every 30 days
It is absolutely essential that the fixture is kept clean and that dust,dirt and smoke fluid residues must not
buildup on or within the fixture. Otherwise, the fixtures light-output will be significantly reduced. Regular
cleaning will not only ensure the maximum light-output, but will also allow the fixture to function reliably
through out its life. A soft lint-free cloth moistened with any good glass cleaning fluid is recommended,
under no circum stances should alcohol or solvents be used!
The front objective lens will require weekly cleaning as smoke-fluid tends to building up residues,reduc-
ing the light-output very quickly.The cooling-fans should be cleaned monthly.
The gobos may be cleaned with a soft brush,The interior of the fixture should be cleaned at least annua-
lly usinga vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the lamp and the fuse.
Please disconnect the power supply before replacing the fuse and bulb. When replacing them, adopt the
same mode.

9.Maintance and cleaning

1500 hours, otherwise it can damage device. Check the running
- 20 -