Power Connection; Dmx-512 Connection/Connection Between Fixtures - Jolly X-7 Coupe User Manual

4.4 Power Connection

If you wish to change the power supply settings, see the chapter appendix Connect the fixture to the
mains with the enclosed power cable and plug.
CABLE(EU)
Brown
Light blue
Yellow/Green

4.5 DMX-512 connection/connection between fixtures

Only use stereo shieded cable and 3-pin XLR-plugs and connectors in order to connect.
Caution
At the last fixture,the DMX-cable has to be terminated with a terminatou. solder a 120 resistor between
signal(-) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
DMX output DMX iutput
3-pin XLR socket 3-pin XLR socket
2 1
3
DMX Terminator Diagram
-For installations where the DMX cable has to run a long distance or
is In an electrically noisy environment it is recommended to use a
DMX terminator. This help in preventing corruption of the signal by
electrical noise. The DMX terminato r is simply an XLR plug witha
Ω
120 resistor connected between pins 2 and pins3, which is then
plugged into a the output XLR socket of the last ifxture in the chain.
CABLE(US)
Black
White
Green
1.6
1:Ground
2:Signal(-)
2 1
2 1
3:Signal(+)
3
3
Warning: please verify the power of the power
supply equipment prior to the connection! Earth wire
must be grounded!
Pin INTERNATIONAL
Live
Neutral
Earth
1.6
DMX output
5-pin XLR socket
5 1
5 1
4 4 2 2
3
3
- 6 -
L
N
1.6
DMX iutput
5-pin XLR socket
1:Ground
2:Signal(-)
5 1
5 1
3:Signal(+)
4 4 2 2
4:N.A.
3
3
5:N.A.
2
1
3
120Ω
PIN2 PIN3