Cleaning The Sensor/Charging Terminal - LG HOM-BOT 2.0 Owner's Manual

CLEANING THE SENSOR/CHARGING TERMINAL

There are sensors on the HOM-BOT 2.0 that can detect obstacles,
stairways and the home station for charging the battery. In order to
maintain the performance of the HOM-BOT 2.0, regularly clean the sensors
and charging terminal as follows:
1. Lay a smooth cloth on the floor, overturn the HOM-BOT 2.0 and put it on
the cloth.
※ Please make sure to remove the dust bin before flipping the main body.
Otherwise, the dust in the dust bin may fall out.
2. Turn off the power switch on the bottom of the HOM-BOT 2.0. Injury can
be caused by the activation of the HOM-BOT 2.0 if the main power is
not turned off.
3. Use a smooth cloth or cleaning brush to wipe the dust off each sensor
and the charging terminal as described below.
Receiving sensor of
remote controller
Camera sensor
Tip
• Do not clean the HOM-BOT 2.0 by directly spraying it with water, thinner, benzene, etc.
• Call the service center if the sensor or charging terminal is damaged. Sensor and terminal
damage can cause the product to malfunction.
26
Charging
terminal
Obstacle detection sensor
Cliff detection sensor
Charging terminal
Bottom camera
sensor
Lens