Cleaning The Sensor/Charging Terminal - LG VCARPETX Owner's Manual

CLEANING THE SENSOR/CHARGING TERMINAL

There are sensors on the Robot Cleaner that detect obstacles,
stairways and the home station for charging the battery. In order to
maintain the performance of the Robot Cleaner, regularly clean the
sensors and charging terminal as follows:
1. Turn off the power switch on the bottom of the Robot Cleaner. Injury
can be caused by the activation of the Robot Cleaner if the main
power is not turned off.
2. Lay a smooth cloth on the floor, overturn the Robot Cleaner and put
it on the cloth.
※ Please make sure to remove the dust bin before rotating the main
body. Otherwise, the dust in the dust bin may fall out.
3. Use a smooth cloth or cleaning brush to wipe the dust off each cliff sensors, camera sensors and
ultrasonic sensors and the charging terminal as described below.
Upper camera
sensor
Tip
• Do not clean the Robot Cleaner by directly spraying it with water, thinner, benzene, or any
other liquids.
• Call the service center if the sensor or charging terminal is damaged. Sensor and terminal
damage can cause the product to malfunction.
• To clean the sensor/charging terminal, use the cleaning brush.
32
Charging terminal
Ultrasonic sensors
Obstacle detecting
sensor window
Detecting sensors
of home station &
Receiving sensors of
remote controller
Cliff detection
sensor
Charging terminal
Bottom camera
sensor
Lens