Cleaning The Dust Bin - LG HOM-BOT 2.0 Owner's Manual

If the dust bin is full, suction power can be weakened. Clean the dust bin before and after each cleaning
session. Clean the dust bin using the following sequence:
1. Open the dust bin cover by pressing the PUSH
button on the HOM-BOT 2.0.
2. Grab the handle of the dust bin and pull it
upward.
3. Separate the HEPA filter and the inside sponge
filter by removing the HEPA filter
※ To clean the dust bin filter, refer to page 24.
4. Lift the cover upward while pressing the
separation button on the dust bin.
5. Empty the dust bin and clean it with a cleaning
brush or under running water.
6. After cleaning with water, completely dry the
dust bin in a well-ventilated area out of the direct
sunlight.
7. When you have completed cleaning the dust bin,
close the cover and replace the sponge filter and
HEPA filter.
8. Put the dust bin into the HOM-BOT 2.0 and
close the dust bin cover.
Tip
• After cleaning, always mount the dust bin filters (HEPA filter, sponge filter) to the dust bin.
If they are not mounted, dust may enter the HOM-BOT 2.0 interior and cause product failure.
• After cleaning the dust bin, make sure to start the operation with the dust bin installed.
If it is operated without the dust bin, voice message, "please check the dust bin" will sound.

CLEANING THE DUST BIN

23