Cleaning The Dust Bin - LG VR648 Series Owner's Manual

If the dust bin is full, suction power can be reduced. Clean the dust bin before or after each cleaning
session. Clean the dust bin using the following sequence:
1. Open the dust bin compartment cover by
pressing the PUSH button on the Robot
Cleaner.
2. Grab the handle of the dust bin and pull it
upward.
3. Pull the hook on the left of Filter Cover on the
rear of Dust Bin to separate the filter and the
sponge.
※ Note that separating the filter may result in
dust dropping.
※ Refer to p.52 when cleaning the Dust Bin
Filter.
4. Lift the dust bin lid upward while pressing the
separation button on the dust bin.
5. Empty the dust bin and clean it with a cleaning
brush or under running water.
6. After cleaning with water, completely dry the
dust bin in a well-ventilated area out of the
direct sunlight.
7. When reassembling or fitting the cleaned Dust
Bin, close the lid and put in the Sponge and
EPA Filter.
※ Refer to p.52 for detailed assembly guides.
8. Put the dust bin into the Robot Cleaner and
close the dust bin compartment cover.
Tip
• Operating the unit without Filters fitted to the dust bin can cause a motor malfunction
not covered by warranty.
• After cleaning the Dust Bin, make sure to assemble the filter and fit it to the Dust Bin.
If you initiate cleaning, with no filters fitted to the dust bin or Filter Cover not assembled,
a voice message will be announced which says "Please check if the dust bin is installed
with the filter."
• Always ensure that the dust bin lid is refitted correctly after
cleaning the dust bin so that it closes easily and accurately.

CLEANING THE DUST BIN

51