Page 1
How to Set-up a DeviceNet Spanner Module G1018 Revised 10/23/2013...
Page 2
“B”. If network B stays without power, all data from cycle power of the module to make a change permanent. node B defaults to 0 value and node “B” LED turns red. www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
2. Set Node B address using address B rotary switches, 3. Set I/O data size using Transfer Size switch, 4. Connect module to networks A and B. 5. Start RSNetWorX. Initial, blank program window www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
Page 4
Transfer Size switch, Figure 1. If Transfer Size switch is set to programmable selection (position 5), you need to edit and change Produced Data Size and Consumed Data Size parameters according to next figure. The same www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
Page 5
Editing I/O parameters enables user to specify exact I/O size of a device that has variable multiple configurations that handles variable data I/ O sizes. The following window pops-up: www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
Page 6
Highlight node 04, press “Options”, select “Word Align” and press OK: Select memory location where input data will be mapped. 1747-SDN scanner supports mapping into two regions: www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
Page 7
8. Click YES to confirm removal of the node from the scan list. 15. Repeat the same to map node B on network B. www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
Page 8
9. Check “Summary” tab to verify that node 4 is NOT in the SLT. Note: Removal of a single node from the scan list will not disturb other nodes or change I/O map of other nodes. www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441...
Need help?
Do you have a question about the FDN-DN1 and is the answer not in the manual?
Questions and answers