1
1) Connector
2) Tie Wrap
3) eAutoFresh Panel
4) Cup, Motor
5) Rail, Top
6) Plate, Gasket
7.28 Electronic Partlow Temperature Recorder
The microprocessor-based temperature recorder is designed to interface with the DataCORDER to log tempera-
ture with time. The electronic recorder will automatically record the return air, supply air, or both, based on the set-
ting of temperature controller configuration code CnF37 (see
from the controller in present time, under normal operating conditions.
If the power has been OFF for more than thirty days, the recorder will NOT re-synchronize (the chart will not
advance to present time), the pen tip will move to the currently recorded temperature, and the recorder will resume
normal temperature recording.
Figure 7.25 Motor Cup Replacement
1
2
5
3
4
12
9
11
10
7) Grille
8) Grill Screws
9) Rail Screws
10) Plate, Slide
11) Rail, Bottom
12) Motor Cup Screws
- - - - -
7–41
6
7
Table
4–4). The recorder reads and records data
8
T-340