Environmental And Waste Disposal Information; Marks Of Conformity - Silvercrest STV 30 A1 Operating Instructions And Safety Instructions

SilverCrest STV 30 A1
Maintenance work is required if the fan has been damaged; for example, if the device housing is
damaged, liquids or objects have got inside the fan or if the fan has been exposed to rain or
moisture. Maintenance work is also required if the fan does not work properly or has been
dropped. If you notice any smoke or unusual noises or smells, disconnect the fan from the mains
immediately. If this happens, you must stop using the fan until it has been checked by a technician.
All maintenance work should only be carried out by qualified specialists. Never open the housing
of the fan. Clean the fan using a clean, slightly damp cloth. Never use abrasive liquids during
cleaning. Use some washing up-liquid on the damp cloth for stubborn stains.
If required, the protective grille (1, 6) can be cleaned with a soft brush.

10. Environmental and waste disposal information

Devices marked with this symbol are subject to the European Directive 2012/19/EU.
Electrical and electronic equipment must not be put in the household waste, but must
be disposed of via designated public disposal centres. By properly disposing of the old
device, you can avoid environmental damage and hazards to health.
Further information on disposing of old devices can be obtained from your local
authority or the shop where you purchased the product.
Make sure that the packaging is disposed of in an environmentally friendly manner.
Cardboard packaging can be put out for waste-paper collection or taken to public
collection points for recycling. The plastic packaging used for your device is collected
by your local waste management company and disposed of in an environmentally-
friendly manner.
Please pay attention to the labels on packaging materials when you separate waste;
these are marked with abbreviations (a) and numbers (b) that mean the following:
1–7: Plastics/20–22: Paper and cardboard/80–98: Composite materials.

11. Marks of conformity

This product fulfils the requirements specified in the applicable European and national
policies. This product's conformity has been verified. The declarations and documents
are stored with the manufacturer. You can download the full EU declaration of
conformity at the following link:
https://www.targa.gmbh/downloads/conformity/331470_1907.pdf
26 – English