Setting The Trip Value - GE CGA 351 User Manual

www.DataSheet4U.com
December 2004
Setting the Trip Type
(cont.)

Setting the Trip Value

www.DataSheet4U.com
4-4
Alarms A..Trip-Type
Above
Below
Above with Fault
POWER ESC
Note: The [Below with Fault] option is also available in the above
list box.
The meter now automatically returns to the "Alarm-Features"
prompt. Either press [ESC] until you exit the User Program or
proceed to the appropriate section to continue setting up the alarms.
Enter the alarm setup menu (see page 4-2) and proceed as follows:
Alarms..Alarm-Feat
Trip Type
Trip Value
Deadband Value
POWER ESC
Note: The [Test] and [Fail-Safe] options are also available in the
above list box
At the next prompt, enter the desired trip point value.
Alarms..Trip Value
ppm
000.00
s
POWER ESC
The meter now automatically returns to the "Alarm-Features"
prompt. Either press [ESC] until you exit the User Program or proceed
to the appropriate section to continue setting up the alarms.
Use the [ ] and [ ] keys to
select the desired trip type, and
press [ENTER].
ENTER
Use the [ ] and [ ] keys to
select [Trip Value], and press
[ENTER].
ENTER
Using the [ ] and [ ] keys,
position the cursor under the
desired character. Then, use
the [ ] and [ ] keys to incre-
ment the value. When done,
press [ENTER].
ENTER
Setup and Calibration