Table of Contents
Advertisement
3. Insert the top and bottom legs of the window filler
panel frame in to the channel in the top angle and
bottom rail. Repeat on the other side.
4. Insert the two 7/16" washing head locking screws
(2) into the holes in the top leg of the filler pane
frame (refer to step 6). Do not completely tighten.
Allow the leg to slide freely. The screws will be
tightened after section 6.
Place the cabinet in the window.
1. Open the window and mark the center of the
window stool as shown (see Fig. 11).
2. Place the cabinet in the window with the bottom
stool angle firmly seater over the window stool.
Bring the window down temporarily behind the
top angle to hold the cabinet in place (see Fig. 12).
3. Shift the cabinet to the left or right (as needed) to
line up the centre of the cabinet on the marked
centre line on the stool.
4. Fasten the cabinet to the window stool with 2
screws into the holes (pilot holes may be pre-drilled).
5. Add the bottom rail seal over the screws to the
window stool.
Installation Instructions
angle
Install the support bracket.
1. Hold each support bracket flush against outside
the sill and tight to the bottom of the cabinet
(see Fig. 14). Mark the brackets at the top level
of the sill, then remove.
2. Assemble the sill angle bracket to the support
brackets at the marked position (see Fig. 15).
Hand tighten to allow for any change later.
Sill angle
bracket
Flat head
bolt
2 screws per support bracket
12
Bottom
rail seal
hex head screw
screws
and locknuts
Hide quick links:
Advertisement
Table of Contents
