How To Install - Arctic King WINDOW/WALL TYPE ROOM AIR CONDITIONER User Manual

Fig.B

HOW TO INSTALL

NOTE: Top rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of
,,
5/16 (8mm). This is
are not using the Side Panels for any reason, this pitch to the rear must be maintained.
1
Place unit on floor, a bench or a table. There is a Left and Right Window Filler Panel- be sure
to use the proper panel for each side. When installed the flange for securing the panel in place to
the window sill will be facing into the room.
Fig.1
A. Hold the Accordion Panel
in one hand and gently
pull back the center to free
the open end. See Fig.1.
Fig.3
Fig.C
necessary for proper condensed water utilization and drainage. If you
B. Slide the free and (I section)
11
C: Align the hole in the top rail with those in the
top of the unit as shown in Fig.B
D: Secure the top rail to the unit with the 3/8
Screws as shown in Fig.C.
NOTE: For safety reasons, all four(4) screws
MUST be securely fastened.
Fig.2B
of the panel into the cabinet
as shown in Fig. 2A, 2B & 3.
Slide the panel down., Be
sure to leave enough space
to slip the top and bottom of
the frame into the rails on
the cabinet.
Meijer.com
,,
Fig.2A