Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs; Adjusting The Tracking - Toro Z Master Commercial TURBO FORCE 3000 Series Operator's Manual

Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
Check that both the mounting hardware and the knobs
are in good working condition. Make sure that the
knobs are fully engaged with the roll bar in the raised
position. The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to get both
knobs fully engaged (Figure 64).
1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward on
the left T-slot until the machine tracks straight
(Figure 65).
47
Figure 64
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-
EUTRAL LOCK
g008943
and
AST