Install The Air Baffles; Connect The Control Cables - ABB ACQ580-04 Series Quick Installation Manual

Step
3
For option +B051:
• Step drill carefully sufficiently big holes to the lead-through clear
plastic shroud for the cables to the connected.
• Align the holes in the vertical direction according to the
alignment holes in the shroud. Smooth the hole edges.
• Remove the plastic sheeting from both sides of the shroud.
• Attach the cables firmly to the cabinet frame to prevent chafing
against the hole edges.
For option +B051: Put the conductors of the input cables
4
through the drilled holes in the clear plastic shroud.
Connect the input power cable conductors to the L1/U1, L2/V1
5
and L3/W1 connection busbars.
For option +B051: Move the lead-through clear plastic shroud
6
along input cables to its final position. Install the front clear
plastic shroud.
7
Install the upper front cover.
Remove the cardboard protective covering from the drive
8
module air outlet.
For option +B051: Cut the hole for the lead-through clear plastic
9
shroud in the side clear plastic shroud. Install the side and top
clear plastic shrouds to the drive module.

Install the air baffles

See figure W on page 16 and Guidelines for planning the cabinet installation in the
hardware manual.

Connect the control cables

See figure X on page 16.
1. Ground the outer shields of all external control cables 360 degrees at the cabinet
lead-through.
2. Ground the pair-cable shields of external control cables to a grounding clamp
below the control unit. Leave the other end of the shields unconnected or ground
them indirectly via a high-frequency capacitor with a few nanofarads, eg, 3.3 nF /
630 V.
3. Connect the conductors to the appropriate terminals of the control unit. See page
10.
4. Wire the optional modules if included in the delivery.
Task (input cables)
Quick installation guide
Figure
R
S
T
U
U
U
V
9
Page
15
15
15
16
16
16
16