Safety Advice; Safety Rules And Regulations - SaMASZ KDT180 Operator's Manual

Fig.3. PTO shaft. PTO shaft lubrication points.
Lubricate the PTO shaft with high quality multi-purpose grease every 8 shaft operating hours
as shown in fig. 3. If access holes are available, lubricate fittings through access holes. E-kits
need lubrication every 50 hours. See decal on guard if applicable.
The mower is equipped with such elements as holders and brackets used to mount warning
lights and plates. Combined lights and reflectors are mounted on the warning plates.

3. SAFETY ADVICE

3.1. Safety rules and regulations.

Front axis of the tractor should be weighted to keep the balance. If need be, use front wheel
weights.
Any operation with the hydraulic lift lever should be done from the operator's seat; DO NOT
move the lever from outside of the tractor.
In case of tractors equipped with EHR, operating with hydraulic lift is done by the buttons
mounted outside the tractor's cabin. When operating be extremely careful.
When switching from working to transport position unmount the whole or at least one end
(from tractor's PTO) of PTO shaft.
Operation without safety guards as well as with the damaged or raised guards is not allowed
(danger of the stones, etc. being thrown out).
Start mowing only when the tractor's PTO reaches its normal 540 rpm.
DO NOT exceed 600 PTO rpm.
Nobody is allowed to remain within the danger area of at least 50 m. Particular caution is
necessary when operating near roads and in stoney areas.
The areas to be mowed should be cleared of any hard objects (stones, etc.). Large stones
should be removed and small ones rolled in during the spring.
Operator's manual
CAUTION:
Optional extra equipment should be ordered separately.
Rear disc mower
KDT180;KDT220;KDT260;KDT300;
- 6 -
KDT340